1. Pull out the ABS inner cylinder, pour water into the silicone container, and the position of more than 2 grids should not exceed 2.5 grids.
2. Slowly insert the inner cylinder with the cover into the silicone cavity (pay attention to rotate and insert it to the bottom and hold it down, and then gently pinch the silicone side under the cover to vent the inner cylinder to prevent the inner cylinder from floating.)
3. Put the mold at room temperature for a few minutes; if you don't want to wait and press hard, you can pour an appropriate amount of hot water into the inner cylinder, pour out the hot water in about 10 seconds, and you can easily pull out the inner cylinder.
4. Squeeze the outer wall of the silica gel and adjust the angle continuously to remove the ice cubes.
